Sartorius ME415S Operating Instructions Manual page 73

Preparation
Turn on the balance: press e
> The Sartorius logo is displayed; the self-test is performed
Select the Density application in the Setup menu: press s
Application parameters
Select the
then the soft key once
O
Application 1 (basic settings)
Select
Density
Select : press the
Density
Confirm : press the
Density Method
Liquid causing
buoyancy
Decimals for disp. of
vol./density
Printout
ο = factory setting
see also the "Application Parameters (Overview)" in the chapter entitled
"Configuring the Balance"
Save settings and exit the Setup menu: press the
72
: press the
or soft key, repeatedly, if necessary
Q q
soft key
O
Density of liquid
ο Buoyancy
Displacement
Pycnometer
ο Water
Ethanol
User-definable
None
1 decimal place
ο 2 decimal places
3 decimal places
4 decimal places
ο None
All data
soft key
oo
soft key 2 x,
q
: press the soft key
O
Additional Functions
In addition to the functions for:
– alphanumeric input,
– taring (not during alphanumeric input),
– printing,
you can also access the following
functions from this application:
Calibration/Adjustment
CAL
Press the soft key
> See "Calibration/Adjustment"
for further instructions
Toggling to the Next Application
Press d
> See the section on the
corresponding application program
for further instructions
Setup (Setting Parameters)
Press s
> See "Configuring the Balance" for
further instructions
Turning Off the Balance
Press e
> The balance shuts off
> The display goes blank, then
OFF or Standby is displayed with
backlighting