Table of Contents
Advertisement
Chapter 6
S
S
TARTING AND
TOPPING
While using PowerScript:
To start PowerScript:
It normally takes about 15 to 30 seconds for PowerScript to power up all the way.
To stop PowerScript:
Doing a System Reset
It is a rare occurrence, but if PowerScript ceases to function during normal operation,
enter Ctrl+Alt+Delete to reset (that is, restart) PowerScript. If this fails to restart Power-
Script, turn the power switch off, wait a few moments, then turn on the power switch
again.
88
P
S
OWER
CRIPT
•
Do not connect or disconnect the mouse or keyboard while PowerScript is running.
•
You can safely leave the Start Card in the card slot when powering down.
•
Enter Ctrl+S to save your work before turning PowerScript off.
1
Insert the PowerScript Start Card in the PC Card slot on the front panel.
2
Turn on the power switch, located on the PowerScript rear panel.
Note
If you are using an Ethernet adapter with PowerScript, you must insert the Power-
Script Start Card in the front slot and the Ethernet adapter in the rear slot—other-
wise, PowerScript will not start. For more information regarding the use of Ethernet
adapters, see Chapter 8, PowerScript Computer Connections .
1
Enter Ctrl+S to save your work, or display the PROJECT/PAGE menu and click the Save
option.
2
Turn off the power switch.
If you don't insert the Start Card before
turning on the power switch, this
picture appears on the screen (after a
few moments) prompting you to insert
the Start Card
Using PowerScript
Hide quick links:
Advertisement
Table of Contents
