Configuring Powerscript With A Single Monitor Having Two Input Jacks; Powerscript With A Single Monitor Having Two Input Jacks - Videonics PowerScript PS4000S Instruction Manual

Postscript graphics and character generator with timebase correction
Table of Contents

Advertisement

Videonics PowerScript
To configure PowerScript in Single-Monitor Mode:
Setup Option
Close Box
You can use PowerScript in single-monitor mode in combination with most of the other
setups described in this chapter. Just keep in mind that the same monitor serves as both
the Preview and Program.
Configuring PowerScript with a Single Monitor having Two Input Jacks

PowerScript with a Single Monitor having Two Input Jacks

Video IN 1
To configure PowerScript to use a single monitor with dual input jacks:
Do the steps in the following section, "Completing the Setup", to configure PowerScript
to use the same monitor for Preview and Program.
1
Connect the monitor to the PREVIEW OUT connector on the PowerScript rear panel.
2
Start PowerScript. See "Starting and Stopping PowerScript" on page 88 for instructions.
3
Enter Ctrl+Right-click to display the MAIN MENU.
4
Click the Setup option.
5
When the SETUP menu appears, click the Display Parameters option to display the fol-
lowing menu.
SETUP: DISPLAY
100%
6
Select the single monitor option (1) in the Monitors section (as shown above).
For additional information, see "Display Parameters" on page 122.
7
Click the Close Box to close the SETUP menu.
Preview / Program
Monitor
Video IN 2
AC INPUT
VOLTAGE
AV
100-240 VAC
PC CARD (PCMCIA)
50-60 Hz
RISK OF FIRE
REPLACE FUSE
TYPE I, II, III
AS MARKED
FUSE RATING
1A FOR 120 VAC
.5A FOR 220 VAC
1
Connect one of the monitor jacks to the PowerScript VIDEO OUT connector on the rear
panel. This connection establishes the Program Monitor.
2
Connect the other monitor jack to the PowerScript PREVIEW OUT connector, also on
the rear panel. This connection establishes the Preview Monitor.

Configuring PowerScript with a Single Monitor having Two Input Jacks

1
2
75%
(NORMAL)
COMPONENT IN
COMPONENT OUT
Y
R-Y (U)
B-Y (V)
Y
R-Y (U)
B-Y (V)
SYNC
SC PHASE
SERIAL
(RS-232)
GPI-1
GPI-2
IN
OUT
TERM
FINE
COARSE
Select Single Monitor option
AUTO
Video
VIDEO IN
VIDEO OUT
PREVIEW
KEY
COMPOSITE
Y/C
COMPOSITE
Y/C
OUT
OUT
25

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Powerscript ps4000sc

Table of Contents