Using Powerscript In Single-Monitor Mode; Configuring Powerscript In Single-Monitor Mode; Powerscript In Single-Monitor Mode - Videonics PowerScript PS4000S Instruction Manual

Chapter 2
U P S
SING OWER CRIPT IN
If you have only one monitor in your setup, you can set up PowerScript to use that mon-
itor as both Preview and Program. See "Configuring PowerScript in Single-Monitor
Mode" below.
If the monitor has dual input jacks, you can use one jack for the Preview Monitor and the
other for the Program Monitor. When using PowerScript, use the monitor switch to tog-
gle the monitor between Preview and Program. See "Configuring PowerScript with a Sin-
gle Monitor having Two Input Jacks" later in this section.
Configuring PowerScript in Single-Monitor Mode

PowerScript in Single-Monitor Mode

24
S -M M
INGLE ONITOR
Tip
Both of the following setups recommend connecting the Preview/Program Monitor to the Pow-
erScript PREVIEW OUT connector. However, you can connect to the VIDEO OUT connector
rather than PREVIEW OUT. The VIDEO OUT connector provides a higher quality signal. In
either case, the Preview/Program Monitor displays the same information.
Note
In order to create this setup, you must have a composite monitor attached to the
PREVIEW OUT connector the first time you turn on PowerScript. Thereafter, you can
set up PowerScript to work in Single-Monitor Mode, as explained herein.
Preview / Program
Monitor
Video IN
AC INPUT
VOLTAGE
AV
100-240 VAC
RISK OF FIRE PC CARD (PCMCIA)
50-60 Hz
REPLACE FUSE
TYPE I, II, III
AS MARKED
FUSE RATING
1A FOR 120 VAC
.5A FOR 220 VAC
ODE
COMPONENT IN COMPONENT OUT
Y R-Y (U) B-Y (V) Y R-Y (U) B-Y (V)
SYNC SC PHASE
SERIAL
(RS-232) GPI-1 GPI-2 IN OUT TERM FINE COARSE COMPOSITE
VIDEO IN VIDEO OUT PREVIEW KEY
Y/C COMPOSITE Y/C OUT OUT
Equipment Setups