Videonics PowerScript
To configure PowerScript as a primary input device:
Turn to "Completing the Setup" on page 26 to configure PowerScript to use two separate
monitors for Preview and Program, then complete the required steps.
1
Connect the Preview monitor to the PREVIEW OUT connector on the PowerScript rear
panel.
2
Connect the mixer or switcher to the VIDEO OUT connector, also on the rear panel.
Optionally, connect the Program monitor to the Program OUT connector on the mixer
or switcher.
Also optionally, connect the VTR to the VTR OUT connector on the mixer or switcher. In
a live broadcast situation, you would probably omit the VTR.
Using PowerScript as a Primary Input Device
19