Using Powerscript In A Video Production, On-Line Studio; Powerscript In A Video Production, On-Line Studio - Videonics PowerScript PS4000S Instruction Manual

Videonics PowerScript
U P S
SING OWER CRIPT IN A

PowerScript in a Video Production, On-Line Studio

To configure PowerScript for use in a video production, on-line studio:
Turn to "Completing the Setup" on page 26 to configure PowerScript to use two separate
monitors for Preview and Program, then complete the required steps.
V P
IDEO RODUCTION
Preview Monitor
Video IN
AC INPUT
VOLTAGE
AV
100-240 VAC
RISK OF FIRE
50-60 Hz
REPLACE FUSE
AS MARKED
FUSE RATING
1A FOR 120 VAC
.5A FOR 220 VAC
Source
Source
Source
Mixer
Source
1 Connect the Preview monitor to the PREVIEW OUT connector on the PowerScript rear
panel.
2 Connect the mixer to the VIDEO IN connector, also on the rear panel.
Optionally, connect the VTR to the VIDEO OUT connector (PowerScript rear panel).
Also optionally, connect the Program Monitor to the Video Out connector on the VTR.

Using PowerScript in a Video Production, On-Line Studio

, O -L S
N INE TUDIO
COMPONENT IN COMPONENT OUT
Y R-Y (U) B-Y (V) Y R-Y (U)
SYNC
SERIAL
(RS-232) GPI-1 GPI-2 IN OUT
PC CARD (PCMCIA)
TYPE I, II, III
Video OUT
B-Y (V)
SC PHASE VIDEO IN VIDEO OUT PREVIEW KEY
TERM FINE COARSE COMPOSITE Y/C COMPOSITE Y/C OUT OUT
Program Monitor
Video IN
VTR
23