Using Powerscript's Internal Key Downstream From A Switcher - Videonics PowerScript PS4000S Instruction Manual

Chapter 2
U P S '
SING OWER CRIPT

Using PowerScript's Internal Key downstream from a Switcher

To configure PowerScript's Internal Key downstream from a switcher:
Turn to "Completing the Setup" on page 26 to configure PowerScript to use two separate
monitors for Preview and Program, then complete the required steps.
22
I K D
S NTERNAL EY OWNSTREAM FROM A
Preview
Monitor
Video IN
AC INPUT
VOLTAGE
AV
100-240 VAC
RISK OF FIRE
50-60 Hz
REPLACE FUSE
AS MARKED
FUSE RATING
1A FOR 120 VAC
.5A FOR 220 VAC
GPI
Device
GPI 1 • GPI 2
GPI
Time
Trigger
GPI 3 • GPI 4
1 Connect the Preview monitor to the PREVIEW OUT connector on the PowerScript rear
panel.
2 Connect the Video Feed (such as a signal from a mixer or switcher) to the VIDEO IN
connector, also on the rear panel.
Optionally, connect the video distribution channel or the VTR to the PowerScript VIDEO
OUT connector.
Also optionally, connect the VTR to the Program Monitor.
3 If you want to use a GPI device to trigger events, connect it to the GPI 1 and/or GPI 2
connectors on the PowerScript rear panel.
S
WITCHER
Video OUT
Video Feed
COMPONENT IN COMPONENT OUT
Y R-Y (U) B-Y (V) Y R-Y (U)
SYNC
SERIAL
(RS-232) GPI-1 GPI-2 IN OUT
PC CARD (PCMCIA)
TYPE I, II, III
Video
Distribution
Equipment Setups
B-Y (V)
SC PHASE VIDEO IN VIDEO OUT PREVIEW KEY
TERM FINE COARSE COMPOSITE Y/C COMPOSITE Y/C OUT OUT
Program Monitor
Video IN
VTR