Table of Contents
Advertisement
Videonics PowerScript
To configure PowerScript to feed a switcher's DSK:
Turn to "Completing the Setup" on page 26 to configure PowerScript to use two separate
monitors for Preview and Program, then complete the required steps.
1
Connect the Preview monitor to the PREVIEW OUT connector on the PowerScript rear
panel.
2
Connect the PowerScript VIDEO OUT connector, also on the rear panel, to the Fill IN
connector on the switcher.
3
Connect the PowerScript KEY OUT connector (rear panel) to the Key IN connector on
the switcher.
Optionally, connect the Program monitor to the Video Out connector on the mixer or
switcher.
Tip
Another possible setup is to connect the PowerScript VIDEO OUT to the Switcher's Video IN
(rather than Fill IN). With this setup you can use the main output signal as a separate source,
or send it to the Fill IN for DSK.
Using PowerScript to Feed a Switcher's DSK (DownStream Key)
21
Hide quick links:
Advertisement
Table of Contents
