Using Powerscript As A Stand-Alone/Live Device; Powerscript As A Stand-Alone / Live Device - Videonics PowerScript PS4000S Instruction Manual

Videonics PowerScript
U P S
SING OWER CRIPT AS A
This setup uses PowerScript, the keyboard, and the mouse as a stand-alone device—that
is, PowerScript is not connected to any other devices (with the exception of the monitor
or monitors).

PowerScript as a Stand-Alone / Live Device

To configure PowerScript as a Stand-Alone/Live Device:
Turn to "Completing the Setup" on page 26 to configure PowerScript to use two separate
monitors for Preview and Program, then complete the required steps.
S -A /L
TAND LONE IVE
Preview
Monitor
Video IN
AC INPUT
VOLTAGE
AV
100-240 VAC
50-60 Hz RISK OF FIRE
REPLACE FUSE
AS MARKED
FUSE RATING
1A FOR 120 VAC
.5A FOR 220 VAC
1
Connect the Preview monitor to the PREVIEW OUT connector on the PowerScript rear
panel.
2
Connect the Program monitor to the VIDEO OUT connector, also on the rear panel.

Using PowerScript as a Stand-Alone/Live Device

D
EVICE
COMPONENT IN COMPONENT OUT
Y R-Y (U) B-Y (V) Y R-Y (U)
SYNC
SERIAL
(RS-232) GPI-1 GPI-2 IN OUT
PC CARD (PCMCIA)
TYPE I, II, III
Program
Monitor
B-Y (V)
SC PHASE VIDEO IN VIDEO OUT PREVIEW KEY
TERM FINE COARSE COMPOSITE Y/C COMPOSITE Y/C OUT OUT
Video IN
17