Videonics PowerScript
Configuring PPP
The following procedures explain how to configure your settings using the Macintosh-
based FreePPP software component. If you are using other configuration software (such
as Config PPP), the settings should be the same, but you enter them in a slightly different
way. Refer to your software documentation for specific instructions.
To enter configuration information using FreePPP (version 2.6.2.):
1
Quit all applications and restart your computer.
2
Open FreePPP.
Note
These instructions use FreePPP version 2.6.2. If you are using a different version, your
screen might look different, but the controls should be the same.
3
Click the Accounts tab, then click New to create a new configuration for PowerScript.
Configuring PPP
Accounts Tab
151