Advantech APAX-5000 Series User Manual page 39

Application Wiring
Note! You can use the jumpers to configure each analog input channel type
(voltage or current). Refer to Section 1.5 for the location of the jumpers.
There are a total of 12 jumpers and each is specific for one channel.
APAX-5017H Specifications
 Channels: 12
Input Impedance: 2M (Voltage), 120  (Current)

 Input Type: V, mV, mA
 Input Range: 0 ~ 500 mV, ±10 V, 0 ~ 10 V, 0 ~ 20 mA, 4 ~ 20 mA
 Configure Different Range for Each Channel: Yes
 Accuracy: ±0.1% or better (voltage), ±0.2% or better (current) at 25C
 Resolution: 12-bit
 Sampling Rate: 1,000 sample/second (per channel)
 Span Drift: ±25 ppm/C
Zero Drift: ±6 V/C

 Input Characteristic Curve: According to IEC 61131-2
 Wire Burnout Detection: Only for 4 ~ 20 mA range
Protection
 Over Voltage Protection: ±35 VDC
 Isolation: 2,500 VDC (Between channels and backplane bus)
Note! The voltage between any two pins must not exceed 15 V
Environment
 Operating Temperature: -10 ~ 60C (when mounted vertically)
 Storage Temperature: -40 ~ 70C
 Relative Humidity: 5 ~ 95% (non-condensing)
Figure 2.6 Wiring for APAX-5017H
31 APAX-5000 I/O Series User Manual