Table of Contents
Advertisement
3. With stranded conductors, use wire end tubes with an insula-
ted sleeve (6) for L1/U, (L2/V), (L3/W), (N) conductors.
Make sure there is no accidental contact, since the supply ca-
ble stays under voltage even when the main switch is off.
4. Crimp a ring terminal to the protection conductor so it stays
fixed to the PE terminal.
5. Connect the supply cable conductors to the incoming termi-
nals (main switch [1]), marked with L1/U, (L2/V), (L3/W),
(N) and the terminal marked with PE. Refer to Figure 27 or
Figure 28 .
6. Provide a sag in the cable, in front of the strain relief. This
will prevent condensed water from dripping into the machine.
Refer to Figure 27 or Figure 28 .
Models outside of North America
4
5
6
1
7
2
3
1. Main switch
2. Strain relief
3. Sag of inlet cable
4. N
5. W
6. V
7. U
Figure 27
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
North American Models
1. Main switch
2. Strain relief
3. Sag of inlet cable
4. L3
5. L2/(N)
6. L1
Machine Protective Earth Connection and
Equipotential Bonding
If there are other washers or appliances with exposed conductive
CHM2488N_SVG
parts, which can touch simultaneously, make sure to make equi-
potential bonding between all these appliances. The external pro-
tective terminal for this purpose is located on the rear panel of the
machine frame. The minimum protection conductor's cross sec-
tion depends on the supply cable cross section (refer to Table
14 ). However, for the protection purposes, with the supply cable
cross section of a min. 4 mm
i.e., 6 mm
49
Figure 28
2
, select a larger conductor section,
2
.
Installation
Part No. D1599ENR14
Hide quick links:
Advertisement
Table of Contents
