Installation
2 Water Connection Models
1. Refer to Table 12 .
2. Refer to Table 12 .
Figure 18
3 Water Connection Models (Optional)
1. Refer to Table 12 .
2. Refer to Table 12 .
3. Refer to Table 12 .
Figure 19
Water
type
1
Table 12 continues...
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
1
2
CHM2510N_SVG
1
3
2
CHM2511N_SVG
Water connection
2
3*
Water
type
Cold and Hot
Cold
Cold soft,
Cold soft
Cold hard and
Hot
*Optional
If the water pressure is below the minimum value,
the wash result can not be guaranteed for a selected
program.
The maximum water inlet temperature for vended models is
151°F [66°C]and the maximum water inlet temperature for on-
premises models is 194°F [90°C] (models without WRAS appro-
val) or 140°F [60°C] (WRAS approved models).
Connections should be supplied by a hot and a cold water line of
at least the sizes shown in Water Supply Line Sizing . Installation
of additional machines will require proportionately larger water
lines.
Connections should be supplied by a hot and a cold water line per
national and local codes and in accordance with IEC 61770.
To connect water service to a machine with hoses, use the follow-
ing procedure:
1. Before installing hoses, flush the building's water system at
the machine connection valves for at least two (2) minutes.
2. Check filters in the machine's inlet hoses for proper fit and
cleanliness before connecting.
3. Hang hoses in a large loop; do not allow them to kink.
If additional hose lengths are needed or using hoses other than
those supplied by manufacturer, flexible hoses with screen filters
are required.
42
Water connection
Hot
N/A
Hot
Cold hard
Table 12
WARNING
Part No. D1599ENR14
W914