Table of Contents
Advertisement
Supply Dispensing
Liquid supply connection size, in. [mm]
Number of diluted liquid soap supply connec-
tions
Diluted liquid soap supply connection size, in.
[mm]
IMPORTANT: Always use liquid soap pumps with a
flow that bring the requested quantity in less than 30
sec.
IMPORTANT: Start pumping immediately after water
valves are open. The incoming water dilutes the liquid
soap and brings it into the tub assembly.
Secure the location of the wiring and hoses so they can not be
pinched, damaged or rubbed. Before you start to use liquid soap,
check with your liquid soap supplier whether the liquid soap is
harmless and inert to PP and PVC material in order to avoid dam-
age to machine.
IMPORTANT: Failure to follow these instructions could
damage the machine and void the warranty.
Connection of External Liquid Supplies
1. Facing the rear of the machine, locate the eight (8) 5/16 inch
[8 mm] supply hose connections found on the left-hand side
of the valve panel. Refer to #d8e18094/fig_z4f_21p_dmand
#d8e18094/fig-1608326066999.
NOTE: Recommended setting of the pump's flow
rate is 60 to 100 liters per hour.
©
Copyright, Alliance Laundry Systems LLC -
DO NOT COPY or TRANSMIT
5/16 [8]
3
7/16 [11.5]
Table 40
1. External Supply Hose Connections
2. Cable Bushing
3. Control Signals Terminal Box
2. Drill through the eight (8) plastic holes on the valve panel for
the external supply hoses as needed.
NOTE: On the valve panel by the external supply
hose connections are three (3) connections of 1/2
in. 12 mm that are to be used only for entering dilu-
ted soap. To use, drill a 7/16 inch 11.5 mm hole only
in connections that will be used.
3. Remove plastic debris.
4. Attach the external supply hoses to the ports at each of the
drilled holes.
5. Secure with proper clamps.
Check that the hose connections are tight (check
the clamps). Any chemical leakage may cause se-
rious bodily injuries as well as serious damage to
the washer. If one of the connections is open,
close and secure the opening with an appropriate
cover.
NOTE: Do not attempt to make chemical injection sup-
ply pump electrical connections to points other than
those provided specifically for that purpose by the fac-
tory.
67
Installation
WARNING
Part No. D1599ENR14
W909
Hide quick links:
Advertisement
Table of Contents
