Table of Contents
Advertisement
AMU Powercon
Installation
2.6.
Cation ex-
changer bottle
Install cation
exchanger
bottle
16
Installation of Cation Exchanger
The bottle containing the cation exchanger is delivered, but not in-
stalled into the flow cell. For transport, an empty bottle has been
installed into the flow cell.
Install the resin bottle as follows:
1 Unscrew and remove the empty bottle [E] from the bottle holder
[B].
2 Fill high purity water into the cation exchanger bottle [C], until
the water level in the bottle reaches the beginning of the thread.
3 Carefully, without spilling water, push the cation exchanger bot-
tle over the inlet filter holder [D] into the bottle holder [B].
4 Screw the cation exchanger bottle into the bottle holder.
Do not tighten the bottle too firmly, this could damage the
gasket.
A
Flow cell
B
Bottle holder
C
Cation exchanger bottle
A
D
Inlet filter holder
E
Empty bottle
B
C
D
E
A-96.250.331 / 230320
Advertisement
Table of Contents
