Table of Contents
Advertisement
AMU Powercon
Program List and Explanations
2.2.2
2.2.2.1
2.3 Sample
2.3.1
2.4 I/O State
2.4.1/2.4.2
2.5 Interface
3 Maintenance
3.1 Calibration
3.2 Simulation
A-96.250.331 / 230320
Miscellaneous:
Case Temp: Shows the current temperature in [°C] inside the trans-
mitter.
Sample ID: Shows the identification assigned to a sample. This
identification is defined by the user to identify the location of the
sample.
Temperature: Shows the current sample temperature in °C.
(Pt 1000): Shows the current temperature in Ohm.
Sample Flow: Shows the current sample flow in l/h and the raw
value in Hz.
Shows current status of all in- and outputs.
Alarm Relay:
Relay 1 and 2:
Input:
Signal Output 1 and 2: Actual current in mA
Only available if optional interface is installed.
Review programmed communication settings.
Follow the commands on the screen. Save the value with the <en-
ter> key.
To simulate a value or a relay state, select the
alarm relay,
relay 1 and 2
signal output 1 and 2
with the [
] or [
Press the <Enter> key.
Change the value or state of the selected item with the [
[
] key.
Press the <Enter> key.
Active or inactive.
Active or inactive.
Open or closed.
] key.
] or
45
Advertisement
Table of Contents
