Stratasys Connex500/350 User Manual page 43

Group
DOC-13025 Rev. A
Purpose
Placing model
files on the build
tray
Pre‐build/build
commands.
Setting model
dimensions.
Cutting,
copying, pasting
and deleting
models.
Moving, rotating
and resizing
models.
•
•
Assigning model
finish and
setting support
strength/
"hollow."
Setting a model's
unit of measure
(millimeters or
inches).
To quickly identify an icon, move the cursor over it to display a tooltip. The
"Undo" and "Redo" tooltips change to reflect your last Objet Studio action.
After activating some of the ribbon commands (by clicking them), they remain
active until you click another button or until you press the Escape key.
When
enabled
Always.
.
Models are on
the build tray.
A model is
selected.
A model is
selected.
A model is
selected.
Assigning a A model is
selected.
material to a
model or
shell.
Separating a
model into
shells.
A model is
selected.
A model is
selected.
Connex500/350 User Guide
Tray Model
Settings Settings
Ribbon Ribbon
5–7