Operating & Maintaining the Connex500/350 3D Printer
6–12
4. In the Compartment Selection screen, select the compartment(s)
containing the printing material you want to replace, and click
Figure 6-9: Compartment Selection screen
5. From the drop‐down menu, choose the material you want to install,
and click
.
Next
Figure 6-10: Material Selection screen
6. The Material Replacement wizard continues as follows:
•
If, according to your selections in the previous wizard screens, you
are replacing both Model material cartridges, and the printer will be
loaded with two cartridges containing the same Model material, the
printer flushes the entire system, and prepares for printing in
Single‐Material mode (see below). Continue with step 8 on page 6‐14.
•
If, according to your selections in the previous wizard screens, you
are replacing both Model material cartridges, and the printer will be
loaded with two different Model materials, the printer flushes the
entire system, and prepares for printing in Digital‐Material mode
(see below). Continue with step 8 on page 6‐14.
•
If, according to your selections in the previous wizard screens, you
are replacing only one of the Model‐material cartridges, and the
.
Next
DOC-13025 Rev. A