Operating & Maintaining the Connex500/350 3D Printer
6–10
You cannot continue printing the model if:
•
The number of the last slice printed does not appear in the printer
interface, even if the server computer displays the Continue from Slice
confirmation dialog box.
•
There was a relatively long interruption in printing, even if the "last
slice" and "continue from slice" indicators are correct. The part of the
model already printed may deform or shrink, and there might be a
visible difference between it and the newly printed part. The effects of a
printing stoppage on a model depend on the model size and structure,
Model material used, ambient temperature and the length of the
stoppage.
If you cannot continue printing:
1. Cancel the print job in the Job Manager screen.
2. Remove the partially printed model from the build tray.
3. Restart the job from the Job Manager screen (in Objet Studio).
You can stop and later resume printing from either the printer interface or
from the Job Manager screen of Objet Studio. After clicking the Stop button
on the printer interface, you can resume printing only from the Job Manager
screen. However, after clicking the Pause button in the printer interface, you
can only resume printing from the printer interface.
DOC-13025 Rev. A