Operating & Maintaining the Connex500/350 3D Printer
6–62
13. In the wizard screen, confirm that you have replaced the lamp(s) and
that the black strip is attached, then click
Figure 6-99: UV-installation confirmation screen
The wizard operates the lamps and checks if their power is within the
acceptable range for each printing mode. (The mode currently being
checked appears in the lower‐left corner of the printer interface.)
Figure 6-100: Status screen during UV lamp check
14. After replacing a UV lamp, it is recommended that you calibrate its
power for the various printing modes. The next screen allows you to
continue to the UV Calibration wizard (see "Testing and Calibrating
the UV Lamps" on page 50).
Figure 6-101: Final wizard screen
.
Next
DOC-13025 Rev. A