Table of Contents
Advertisement
Operating & Maintaining the Connex500/350 3D Printer
6–18
3. Choose the appropriate option for the length of time that the printer
will not be used—less or more than ten days.
Note: Before selecting More than 10 days, make sure that cleaning-fluid
cartridges are available.
Figure 6-16: Shutdown options
4. In the next screen, verify that the tray is empty and click
The shutdown procedure begins.
Figure 6-17: Shutdown progress screen
5. When the final wizard screen appears, close the printer‐control
application and shut down the built‐in computer.
Figure 6-18: Final Shutdown wizard screen
6. After the printer computer shuts down, turn off the main power switch
at the back of the printer (see figure 6‐2 on page 2).
.
Next
DOC-13025 Rev. A
Advertisement
Table of Contents
