DOC-13025 Rev. A
9. Click
, and take note of the warning screen.
Next
Figure 6-13:
Material Replacement warning screen
Once you start this procedure, you must complete it before you can produce
models with the Connex printer. To perform the procedure at another time,
click Cancel. If you continue (by clicking Next) and you do not complete the
procedure, you must start the Material Replacement wizard again before
producing models.
10. Click
Next
.
11. When prompted, load the new cartridge(s). Confirm this in the wizard
screen and click
Next
After identifying the cartridge(s), the printer begins filling the print
heads with the new Model material.
The approximate time needed for this process appears in the wizard
screen, and the elapsed time is displayed.
Figure 6-14: Material replacement: filling heads with new material
12. Click
to close the wizard.
Done
The printer‐control application is automatically updated, and the
interface displays the new material(s). The Objet Studio application (on
the printer‐server computer) is also updated and displays the new
material(s).
13. Inspect the area around the purge unit and clean it, if necessary.
CAUTION: Dispose of all material cartridges in accordance with all
applicable laws and regulations. If necessary, the cartridges can be
disassembled for recycling. If this is done, protect the person handling
the cartridges from direct exposure to uncured resins.
Connex500/350 User Guide
.
6–15