Table of Contents
Advertisement
Operating & Maintaining the Connex500/350 3D Printer
Block temp.
behind
Support heads
Temp. of each
Support head
Block temp.
in front of
Support heads
Waste weight
Chamber temp.
Left UV lamp
Right UV lamp
6–6
The Connex500/350 printer uses one or two Model‐material cartridges and
one Support‐material cartridge to produce models. If additional cartridges
are installed and they are not needed for the current print job, the printer
interface indicates which are being used:
•
Blue cartridge—used for the print job
•
Gray cartridge—not used for the print job
You can monitor printer status indicators by switching the printer interface
display. To do this, click the display toggle button in the printer interface
screen.
Figure 6-4: Printer indicators
Block temp.
behind Model
heads
Temp. of each
Model head
Block temp. in
front of Model
heads
Support/Model
material in print-
block reservoir
System
vacuum level
Pre-heating of
Support & Model
material
Display
toggle button
Printer set to
online mode
(green)
DOC-13025 Rev. A
Advertisement
Table of Contents
