Operating & Maintaining the Connex500/350 3D Printer
Test Interface The Built In Tests screen lists pre‐configured tests, grouped by component
Test List
6–64
categories. In this screen, you select and run tests, and the results are
displayed.
Figure 6-103: Built In Tests screen
Test Name
This column lists all of the tests, together with selection check boxes.
Click the check boxes to select the tests you want to run. To remove a
selection, click the check box again. To quickly select all of the tests in a
component category, use the Group drop‐down list at the bottom of the
screen.
Group
This column shows the component categories for each test.
This tells you which tests are run when selecting a category from the Group
drop‐down list at the bottom of the screen.
Status
This column shows the results of each test after you run it:
Test successfully completed.
Test failed.
Unknown results. (The test has not been run yet.)
DOC-13025 Rev. A