DOC-13025 Rev. A
To prepare a new waste container:
1. Assemble the cardboard box, making sure to punch out the perforated
sections.
2. Place a new plastic container into the box.
Note: Do not close the box until you connect the waste drain tube from the
printer.
To replace the waste container:
1. Open the front doors of the printer.
Figure 6-105: Accessing the waste container
2. Carefully slide out the waste container to remove it from the printer.
3. Place the new waste container next to the full container.
4. Unscrew the cap securing the waste drain tube and connect it to the
new container.
5. Close the full container with the cap supplied with the new waste
container.
6. Close the new waste‐container box, using tape to hold it closed.
7. Position the waste container under the printer, on the load cells.
•
The container should be on the extreme right side of the
compartment.
•
Make sure that the waste drain tube is not crimped and that it is not
pinched by the container.
8. Close the waste compartment door.
Dispose of the full waste container in accordance with environmental and
safety requirements.
Connex500/350 User Guide
6–69