Stratasys Connex500/350 User Manual page 179

DOC-13025 Rev. A
10. Insert the new UV lamp/reflector unit into the housing next to the print
block.
UV lamp
assembly
Black strip
Figure 6-96: Print block and UV lamp assembly, showing correct placement of
black strip
11. Replace the lamp cover by inserting it into the slot on the bottom of the
housing, and tighten the securing screw on top.
Figure 6-97: Replacing the lamp cover
12. Reconnect the power and heat fuse connectors.
Figure 6-98: Connecting the UV lamp
Connex500/350 User Guide
UV lamp
assembly
Black strip
6–61