At the same time, the limit switch starts a pneumatic timing el-
ement that retracts the press cylinder again after the set delay
expires.
Pivot the hand lever upwards.
the return stroke of the press is supported by the return spring when moving
back (can be adjusted by the return stroke limitation on the left of the press
carriage).
1
2
The return stroke limitation or the length of the approach stroke
cannot be adjusted for models with the measurement system.
–
HKPL-DS
Translation of the original operating manual
Setup and accessories
Elbow joint
T-groove screw
Stop washer
3
Hex nut
68
Adjusting the approach stroke
8
1
2
3