Table of Contents
Advertisement
6.
Commissioning / Operation
Observe the safety chapter
The basic safety information for the press is located in the "Safe-
ty Information" chapter.
In addition, observe all safety instructions in the manufacturer
documentation found in the appendix.
Note the hazardous areas. See the chapter "Working, service and protec-
tion area"!
After switching on the system, do not perform any cleaning work in the
action areas of the system!
6.1
Commissioning
Check the system and all associated electrical mechanical components for
damage!
Risk of injury from damage and defects
Specify the responsibility of the commissioning personnel.
Before commissioning, check the press to ensure it has the cor-
rect setting and ensure the presence of the required protective
and safety devices. If defects are identified, stop the press until
these defects are rectified.
Immediately replace defective press components. Use the addi-
tional documents in the appendix of this operating manual to en-
sure an undoubted identification of the component.
Do not remove or bypass any safety devices or work without
them.
Check the installation conditions during the initial commissioning
or after a longer standstill!
–
HKPL-DS
Translation of the original operating manual
Commissioning / Operation
45
6
Advertisement
Table of Contents
