Wiring Diagrams - Sargent ASSA ABLOY SE LP10 Installation Instructions Manual

SE LP10 Cylindrical Lock

Wiring Diagrams

6
Product
1-Black 2-Red
ACCESS CONTROL DEVICES: SE LP10 Cylindrical, ElectroLynx wire Color / Function assignments
SARGENT - 12VDC
SE LP10 (Reader)
Cylindrical
NEG POS
*Diagrams on following pages
Default Operation Mode:
• Red LED 'ON' when powered.
• Presenting a 13.56MHz or 125 kHz credential causes LED to briefly turn green and then return to
red state.
• Presenting a FIPS 201 PIV credential causes LED to turn amber as credential is authenticated.
Reader emits a short beep when credential is successfully read. Reference Diagram #1.
Optional TAMPER Operation Mode:
• Connect Yellow TAMPER wire from ElectroLynx cable to desired EAC panel control line.
Reference Diagram #1.
• As appropriate, use the configuration card to activate desired mode on reader.
PIN 8 (Yellow – TAMPER)
PIN 6 (Blue – RX COM)
PIN 4 (Green – Data 0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – Data 1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
Optional Alternate Indicator Mode:
• Connect GREEN_LED input to switch controlled by panel. Shorting GREEN_LED to READER_NEG
(Black) with panel switch will override reader LED to keep it green.
PIN 8 (Yellow – Green LED)
PIN 6 (Blue – RX COM)
PIN 4 (Green – Data 0)
PIN 2 (Red – Reader POS)
PIN 1 (Black – Reader NEG)
PIN 3 (White – Data 1)
PIN 5 (Orange – RX NO)
PIN 7 (Brown - EGND)
A8117G • 800-810-WIRE (9473) • www.sargentlock.com
8 PIN CONNECTOR
3-White 4-Green 5-Orange
WIEGAND WIEGAND RX
DATA_1 DATA_0 NO
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)
PIN 4 (Tan –DPS COM )
PIN 2 (Gray – Lock POS)
PIN 1 (Violet – Lock NEG)
PIN 3 (Pink – DPS NC)
6-Blue 7-Brown 8-Yellow 1-Violet
RX EGND TAMPER
GREEN_LED*
COM EGND OPEN
COLLECTOR
INPUT
Note: NC= Normally Closed
9
4 PIN CONNECTOR
2-Gray 3-Pink 4-Tan
12/24 VDC DPS DPS
(LOCK RELAY)
NEG POS NC COM
NO= Normally Open