Taylor 632 Operator's Manual page 27

9. Slide the two O-rings into the grooves on the prime
plug. Apply an even coat of Taylor Lube to the O-
rings and shaft.
Figure 6-6
10. Insert the prime plug into the hole in the top of the
freezer door, and push down.
Figure 6-7
11. Install the freezer door. Insert the baffle rod through
the opening in the beater and seat the door flush with
the freezing cylinder. With the door seated on the
freezer studs, install the handscrews. Tighten them
equally in a crisscross pattern to insure the door is
snug.
Figure 6-8
Operating Procedures
All manuals and user guides at all-guides.com
Model 632
OPERATING PROCEDURES
12. Install the draw valve. Slide the two O-rings into the
grooves on the draw valve, and lubricate them.
Figure 6-9
13. Lubricate the inside of the freezer door spout, top
and bottom, and insert the draw valve from the
bottom until the slot in the draw valve comes into
view.
Figure 6-10
14. Install the adjustable draw handle. Slide the O-ring
into the groove on the pivot pin, and lubricate it.
Figure 6-11
6
6-3