Taylor 632 Operator's Manual page 30

OPERATING PROCEDURES
4. If the blades are in good condition, place the rear
scraper blade over the rear holding pin on the beater
(knife edge to the outside). Holding the rear blade on
the beater, slide the assembly halfway into the
freezing cylinder, tail end first. Install the front scraper
blade over the front holding pin. Slide the beater
assembly completely into the freezing cylinder.
Note: To prevent costly damage, the hole on the
scraper blade must fit securely over the pin.
5. Before assembling the freezer door, check the
following for any nicks, cracks, or signs of wear: the
front bearing, door gasket, draw valve, O-rings, and
6
all sides of the door assembly, including the inside of
the draw valve bore. Replace any damaged parts.
6. Slide the two O-rings into the grooves on the draw
valve and lubricate the bottom 1/2 of the valve.
7. Lubricate the inside of the freezer door spout, top
and bottom, and insert the draw valve into the freezer
door from the top. It will be necessary to rotate the
draw valve to the right when assembling the door to
the freezer.
6-6
All manuals and user guides at all-guides.com
Figure 6-20
Figure 6-21
11531c
8. Place the freezer door gasket into the groove on the
back of the freezer door. Slide the front bearing over
the baffle rod so the flanged edge is against the door.
Do not lubricate the gasket or bearing.
9. Insert the baffle rod through the beater in the freezing
cylinder. With the door seated on the freezer studs,
install the handscrews. Tighten them equally in a
criss-cross pattern to insure the door is snug.
Model 632
Figure 6-22
Figure 6-23
Figure 6-24
Operating Procedures