Installing The Load To The Slider; Using The Slider - IAI ROBO Cylinder RCS2 Series Operating Manual

7.4

Installing the load to the Slider

7.4.1

Using the Slider

 Tapped holes are provided on the slider for installing the load. The method of clamping varies
according to how to mount the main body.
 In case of moving actuator instead of slider, use the same tapped holes on the slider.
 Please use two reamed holes on the slider when repeatability of mounting and dismounting is required.
When fine adjustment of the squareness is necessary, use only one reamed hole to allow adjustment.
Sizes and depths of tapped holes and reamed holes on slider
Model Tap size
SA4 M3
SA5 M4
SA6 M5
SA7 M5
SS7 M5
SS8 M8
Caution: When installing the load, do not let adhesives, paints or other viscous substances
attach the stainless sheet. Also, avoid applying a concentrated force that will dent
the sheet. It may cause the slider to malfunction or damage the sheet.
Depth of thread
7 mm 24 mm
9 mm 30 mm
9 mm 50 mm
10 mm 50 mm
10 mm 50 mm
10 mm 75 mm
Tapped hole
A B C
16 mm 20 mm
19 mm 26 mm
32 mm 31 mm
32 mm 39 mm
32 mm 32 mm
45 mm 45 mm
Reamed hole
Reamed hole
3 H7, depth 5 mm

4
H7, depth 6 mm
5 H7, depth 6 mm
5 H7, depth 10 mm
5 H7, depth 10 mm

8
H7, depth 10 mm
17