Table of Contents
Advertisement
Function
Sequence of operations 1. Enter the menu by typing the supervisor code.
58
7.17. Resetting the default settings (15. menu item)
In this case all the settings are deleted, and the default
factory setting is restored.
Using this function makes sense in that case, when the
settings of the instrument have changed so much, that it is
easier to start the setting-up process from the default
factory setting.
It is not possible to cancel this operation once the command
has been issued.
The way the code should be type in is described in Chapter
7.1. Typing the code in. You see this on the display:
.
2. Keep stepping by pressing the ▲ button as long as you
see this menu item:
3. Enter the menu item by pressing the ENTER button.
4. The mnemonic
mnemonic is blinking.
Now you still have the possibility to exit. If you want to exit,
as you do not want to reset the default settings after all,
press the MENU button. This takes you out from this menu
item, and you see this:
5. If you want to reset the default settings, press the ▲
button to change the „NO" to „YES".
•
= I do not want to reset the default settings
•
= I want to reset the default settings
6. Press the MENU button.
The instrument displays the mnemonic
the mnemonic
.
According to the factory settings, it measures the loop
current with a resolution of three decimals.
.
is shown on the display. The
.
(ready). After then it restarts:
DT9002
(busy), then
20180621-V1
,
Advertisement
Table of Contents
