At no point in this procedure should you turn the processor
CAUTION :
unit on its s ide or on its back .
Cable Harness
Retaining Bar
Retaining
Screw
Figure 5 - 15 .
Processor Unit Cab le Harness (Top View)
Remove the two printer/plotter thumbwheel mounting screws located
7 .
on the underside of the unit .
8 .
Holding the printer/plotter by the front , t i lt the front up and l i ft
unti l the hooks at the top release from the processor unit .
the printer/plotter out two or three inches from the processor unit .
See Figure 5 - 1 8 .
9 .
Carefully pul l the control board AC cable out o f the processor unit .
See Figure 5 - 1 5 .
Disconnect the fan AC connecto r . See Figure 5 - 1 9 .
1 0 .
Retaining
Screw
Print Head
Connector
See Figure 5 - 1 6 .
Removal and Replacement Procedures 5 - 24
(4)
Plastic Screws
P500
Move