Table of Contents
Advertisement
Place the CRT disp l ay unit and bridge assembly on the processor unit
4 .
over the bridge mount ing holes . See Figure 5 - 2 .
Secure the as sembly t o the processor unit by t ightening the four
5 .
knurled thumb s crews on the bridge . See Figure 5 - 2 .
6 .
Reconnect the CRT display cable and plug the main power cord into
the wall out let . See Figure 5 - 1 .
Position the IBM 9001 power switch to ON and do an operational check
7 .
of the system .
5 . 1 3 . 3
REMOVAL D I SKETTE D R I V E ASSEM B LY
Stop a l l diskette activity and remove the diskette ( s ) .
1 .
Position the diskette drive assemb ly ' s power switch to "OFF . "
2 .
Disconnect the power cord and a l l other connectors on the rear o f
3 .
the diskette drive assemb ly . See Figure 5 - 2 2 .
Remove the four s crews securing the diskette drive as sembly ' s cove r .
4 .
Remove the cove r .
Disconnect the power connecto r , ground c l ip , and ribbon connectors
5 .
from the back of the diskette drive being removed .
6 .
Remove the two s crews securing the diskette drive t o the hous ing .
See Figure 5 -23 .
S l ide the diskette drive toward the front and out of the housing.
7 .
8 .
To remove the other diskette drive , repeat steps 5 - 7 .
See Figure 5 -2 3 .
Removal and Replacement Procedures 5 - 3 4
See Figure 5 - 2 4 .
Advertisement
Table of Contents
