Cleaning Or Installing The Filter - Christie HS Series Installation And Setup Manual

Cleaning or installing the filter

Regularly clean or replace the filters in the projector to ensure dust and other foreign materials are
kept out of the projector.
1. Turn off the projector.
2. Remove the screws on the filter cover using a 3 mm hex key.
3. Remove the filter cover.
4. Remove the filter from its compartment.
5. Clean or replace the filter.
Fog filters should be replaced after each use of the projector to a maximum of 20 hours. The life of
the filter is approximately 20 hours based on environmental conditions. Leave the filters in their
sealed packaging until ready for use.
Do not re-use the fog filters as they clog up with oil and the projector overheats and shuts down.
HS Series D16-20 Installation and Setup Guide
020-001464-02 Rev. 1 (10-2018)
Copyright ©2018 Christie Digital Systems USA Inc. All rights reserved.
Left side filter
Right side filter
Installation and setup
25