Table of Contents
Advertisement
To change the operating parameters of the module, you must access its Local Management
program by either a module COM port connection or by a Telnet connection to the module. This
chapter provides the following sections on how to make these connections:
•
Management Terminal Setup
to the module COM port.
•
Telnet Connections
connection to access Local Management.
2.1
MANAGEMENT TERMINAL SETUP
The module provides one communication port, labeled COM, which supports a management
terminal connection. To access Local Management, connect one of the following systems to the
COM port:
•
Digital Equipment Corporation VT series terminal.
•
VT type terminal running emulation programs for the Digital Equipment Corporation VT series.
•
IBM or compatible PC running a VT series emulation software package such as HyperTerminal,
which is included in the Windows 9x operating system.
•
You can also access Local Management using a Telnet connection through one of the network
ports of the module.
2.1.1
Console Cable Connection
Use the Console Cable Kit provided with the module to attach the management terminal to the
module COM port as shown in
Local Management Requirements
(Section
2.1), which describes how to make a terminal connection
(Section
2.2), which provides guidelines on how to make a Telnet
Figure
2-1.
Local Management Requirements
2
2-1
Advertisement
Table of Contents
