Table of Contents
Advertisement
1.2
NAVIGATING LOCAL MANAGEMENT SCREENS
To navigate within a Local Management screen, use the arrow keys of the terminal or the
workstation providing terminal emulation services. The Local Management screen cursor responds
to the LEFT, RIGHT, UP, and DOWN arrow keys. Each time you press an arrow key, the Local
Management screen cursor moves to the next available field in the direction of the arrow key.
The Local Management screen cursor only moves to fields that can be selected or used for input.
This means that the cursor jumps over display fields and empty lines on the Local Management
screen.
The Local Management screen cursor provides wrap-around operation. This means that a cursor
located at the edge of a screen, when moved in the direction of that edge, "wraps around" to the
outermost selectable item on the opposite side of the screen which is on the same line or column.
1.3
LOCAL MANAGEMENT REQUIREMENTS
The module provides one communication port, labeled COM, which supports a management
terminal connection. To access Local Management, connect one of the following systems to the
COM port:
•
Digital Equipment Corporation VT series terminal.
•
VT type terminal running emulation programs for the Digital Equipment Corporation VT series.
•
IBM or compatible PC running a VT series emulation software package such as HyperTerminal,
which is included in the Windows 9x operating system.
You can also access Local Management using a Telnet connection through one of the network
ports of the module.
NOTE: For details on the setup parameters for the console, how to connect a console
to the module, or how to make a telnet connection, refer to
Navigating Local Management Screens
Chapter
2.
Introduction
1-3
Advertisement
Table of Contents
