Enterasys Matrix E5 5H153-50-G User Manual page 101

Field Descriptions
Refer to Table 7-14
Table 7-14 Extended Bridge Configuration Screen Field Descriptions
Use this field...
Extended Multicast
Filtering Services
Traffic Classes
Static Entry Individual
Port
Configurable PVID
Tagging
Local VLAN Capable
VLAN Learning
Auto VLAN Backplane
Configuration
Host VLAN ID
for a functional description of each screen field.
To...
See if the filtering of individual multicast addresses based on
Multicast Registration Protocol is active.
NOTE: This function is not available for the current
firmware release.
See the mapping of user priorities to multiple traffic classes
function is active. (For configuration information, refer to
Section 7.10.)
See if the static filtering for unicast and multicast addresses
function is active. (For configuration information, refer to
Section 7.16.)
Override the default PVID setting (Port VLAN ID used in frame
tags) and its egress status (VLAN-Tagged or Untagged) on each
port. For details, refer to
This switch does not support multiple local bridges (that is,
multiple Spanning Trees).
Select the VLAN Learning mode (IVL or SVL) used by the switch.
IVL (Independent VLAN Mode) – Allows addresses to be
learned per VLAN.
SVL (Shared VLAN Mode) – Allows a single address for all
VLANs.
Enable or disable the ports on the backplane to support automatic
configuration of VLANs. The default is Enabled.
When set to Disabled, you must configure VLANs manually. For
information on how to configure VLANs manually, refer to
Section 7.15.
Enter the Host VLAN ID and it is not limited to the default VLAN
(1).
Extended Bridge Configuration Screen
Section 7.15.
Device Control Menu Screens 7-29