Using Setup; Getting Help; In Case Of Problems; A Final Note About Setup - Contec IPC Series User Manual

Using Setup

In general, you use the arrow keys to highlight items, press <Enter> to select, use the Page Up and Page Down
keys to change entries, press <F1> for help and press <Esc> to quit. The following table provides more detail
about how to navigate in the Setup program using the keyboard.
Table 4.1. Using Setup
Key
Up Arrow
Down Arrow
Left Arrow
Right Arrow
Esc
Move Enter
+ key
- key
F1 key
F2 key
F3 key
F4 key

◆Getting Help

Press F1 to pop up a small help window that describes the appropriate keys to use and the possible selections
for the highlighted item. To exit the Help Window press <Esc> or the F1 key again.

◆In Case of Problems

If you cannot boot the computer after using Setup to change and save system settings, the computer will have
to be repaired. It is safest not to change system settings you do not fully understand. Therefore, it is strongly
recommended that you do not change any of the default settings for the chipset. These defaults have been
selected with sufficient consideration by the AMI and system manufacturers to ensure maximum performance
and reliability. Even changing the chipset settings slightly can result in an unavoidable need for repairs.

◆A Final Note About Setup

The information in this chapter is subject to change without notice.
PT-S2000HX/HXC/LX/LXC Series User's Manual
Move to the previous item
Move to the next item
Move to the item on the left (menu bar)
Move to the item on the right (menu bar)
Main Menu: Quit without saving changes
Submenus: Exit Current page to the next higher level menu
Move to the item you desired
Increase the numeric value or make changes
Decrease the numeric value or make changes
General help on Setup navigation keys
Load the previous settings
Load the optimal defaults from the BIOS default table
Save all the changed settings to the FLASH ROM and exit
Function
29