Installation; Servo Drive Installation - Parker FL20-CA Series Product Manual

III. Installation

3.1 Servo drive installation

3.1.1 Installation conditions
Equipment
location
Altitude/level
Atmospheric
pressure
Operating
Environment
temperature
Conditions
Storage
temperature
Humidity
Vibration
Strength
IP rating
Power
system
Note: TN system: A power distribution system having one point directly earthed, the exposed
conductive parts of the installation being connected to that points by protective earth conductor.
3.1.2 Installation precautions
To make good effect of cooling circulation, user needs to ensure to leave enough space for
ventilation when installing servo drive. The typical minimum installation dimension is shown as
below in figure 3.1.1.
CAT5E
shielded cable
Fig 3.1.1 typical min installation dimension
FL20-CA Series
In an indoor location, preventing exposure from direct sunlight,
free from dust, tangy caustic gases, flammable gases, steam or the
salt-contented etc.
1000m and below(derate use if over 1000m)
86kPa~106kPa
-10℃~40℃
-20℃~60℃
0~ 90% RH (no water-bead coagulation)
）,10~60Hz (Discontinuous)
2
Below 0.5G（4.9m/s
IP20
TN system (Note)
> 200 mm
Servo Drive
>20mm >20 mm
>50mm
34