The Configuration Screen - Cabletron Systems HubSTACK SEHI-34 User Manual

LOCAL MANAGEMENT
6.3.2 The Configuration Screen
To access the Configuration screen from the Feature Selection screen,
use the arrow keys to highlight the IP Address Assignment option
then press the Return key or F7. The Configuration screen shown in
Figure 6-5 appears.
The SEHI Configuration screen lets you assign the IP Address, Subnet
Mask, and Default Gateway. You can also use the Port Enable
Override option to enable all device ports in the stack. This option
overrides the Port Disable setting in the Statistics screen.
The following sections explain each field on the Configuration screen
and instructions on how to change them.
I/F
Gives the number of the interface corresponding to the channels over
which packets with that IP Address are passing. On the SEHI, this
value is always 1.
IP Address
Displays the IP address of the SEHI.
Page 6-10
SEHI LOCAL MANAGEMENT
Cabletron SEHI Revision X.XX.XX
CONFIGURATION
I/F IP Address
1 000.000.000.000
Default Gateway: 0.0.0.0
Serial Port 1 Application: CONSOLE
Port Enable Override: OVERRIDE DISABLED
SAVE COMMUNITY NAMES
F6 F7
Figure 6-5. Configuration Screen
SubNET Mask MAC Address
000.000.000.000 00-00-1d-05-dc-36
Baud Rate: 9600 --ACTIVE--
TRAP TABLE SNMP TOOLS
F8 F9
RETURN