Rack Mounting The Sehi - Cabletron Systems HubSTACK SEHI-34 User Manual

3.2.3 Rack Mounting the SEHI

Refer to Figure 3-4 and perform these steps to install the SEHI in a
19-inch rack.
1. Remove four cover screws (two from each side) located along the
front edges of each side of the SEHI.
2. Using the four cover screws removed in step 1, attach the rack
mounting brackets to each end of the SEHI.
HubSTACK
SEHI-24
Figure 3-4. Installing the Rack Mount Brackets
3. With the mounting brackets installed, position the SEHI between
the vertical frame members of the 19-inch rack and fasten it
securely with the mounting screws as shown in Figure 3-5.
HubSTACK
SEHI-24
Figure 3-5. Installing the SEHI in the Rack
Wall/Rack Mounting
10BASE-T HUB LANVIEW®
WITH
19-Inch Rack
10BASE-T HUB LANVIEW®
WITH
Screws (4)
Brackets (2)
Screws (4)
INSTALLATION
Page 3-5