Wall Mounting The Sehi - Cabletron Systems HubSTACK SEHI-34 User Manual

INSTALLATION

3.2.4 Wall Mounting the SEHI

When you wall mount the SEHI, the cable connections must face
down. Refer to Figure 3-6 and perform the following steps to wall
mount the SEHI.
Note: 1/4-inch Molly screw anchors for wall mounting are not
included with the SEHI-ACCY-KIT package.
1. Use the supplied screws to attach the wall mounting brackets to
the bottom of the SEHI as shown in Figure 3-6. There are two
brackets, one for each side.
Molly Screw
Anchors
Bracket Screws
2. Select the wall location for the SEHI within 7 feet of a power outlet.
Warning: There is a potential SHOCK HAZARD if there is electrical
wiring within the wall that interferes with drilling for pilot holes. Select
a wall location where drilling pilot holes for the Molly screws will not
come in contact with electrical wiring in the wall.
Page 3-6
Wall Mounting Bracket
Figure 3-6. Wall Mounting the SEHI
Molly Screws