Table of Contents
Advertisement
3. You will need a pencil for this step. With the wall mounting
brackets attached to the SEHI, position the SEHI against the wall
where it will be permanently mounted with the network port facing
down. Use the pencil to mark the wall location for the four pilot
holes.
4. Set the SEHI aside and carefully drill four 1/4" pilot holes, one for
each of the Molly screw anchors and insert the four Molly screw
anchors into the holes just drilled.
5. Tighten each of the anchor screws until the anchor expands holding
the anchor firmly in the wall, then remove the screws completely.
6. Position the SEHI on the wall over the anchors and reinstall the
four anchor screws to attach the SEHI to the wall, as shown in
Figure 3-6. Tighten the four anchor screws.
3.2.5 Free-Standing Installation
For a free-standing shelf or tabletop installation, locate the SEHI
within 7 feet of its power source and with an unrestricted free surface
area 21 inches wide, 18 inches deep and 6 inches high, as shown in
Figure 3-7.
18 IN.
6 IN.
Figure 3-7. Shelf or Table-top Installation
HubSTACK
10BASE-T HUB
LANVIEW®
WITH
SEHI-24
21 IN.
7 FT.
INSTALLATION
Page 3-7
Advertisement
Table of Contents
