Table of Contents
Advertisement
Section 4 – Inspections Before Operation
10
14. Press the sensor bar for less than 1 second and
then release it.
Result: The function will stop while the bar is
▪
pressed and the function will continue when
the bar is released. The audible/visual alarm
goes on while the bar is pressed and goes off
after it is released. The reset button illuminates
when the bar is pressed and goes off when the
bar is released.
15. Press the sensor bar for more than 1 second
and then release it.
Result: The function will stop and the audible/
▪
visual alarm goes on immediately and stays
on after the bar is released. The engine stops
after 1 second. The reset button illuminates.
16. While the audible/visual alarm
sure the LED strobe light is also on.
4.3-15 Do a test of the engine start/on/off
switch
1. Make sure the engine is on.
2. Select the off position from the engine start/on/
off
switch.
10
Result: The engine stops and the platform
▪
control console is disabled.
3. Select the on position from the engine start/on/
off switch.
Result: The platform control console is
▪
enabled.
4. Select the start position from the engine start/
on/off switch to start the engine.
213205AAA
56
11
TM
1
3
=
STOP
2
+
+
4
12
is on, make
9
4.3-16 Do a test of the emergency power
unit
CAUTION
Do not operate more than one function at a time
when you use the emergency power. If you do so,
it will overload the 12-Volt emergency pump motor.
NOTE
To conserve the battery power, do a test of each
function through part of a cycle.
1. Push the emergency-stop button to turn the
engine off.
2. Pull the emergency-stop button.
3. Select the on position from the engine start/on/
off switch.
4. Press and hold the footswitch.
5. Select the emergency-power unit switch
and operate each function control handle or
switch.
Result: All the boom functions operate. The
▪
drive and steer functions do not operate.
4.3-17 Do a test of the manual platform-
leveling
1. Start the engine.
2. Press and hold the footswitch.
3. On the platform-leveling override switch
, select the up position to tilt the platform up or
the down position to tilt the platform down.
Result: The platform tilts up or down.
▪
Function tests
9
11
12
SJ82 T, SJ86 T
Advertisement
Table of Contents
