Table of Contents
Advertisement
Section 6 – Additional Procedures
6.2 Chassis tilt recovery
IMPORTANT
When you raise or extend the boom, the MEWP
must be on a firm, level surface.
WARNING
Tip-over hazard. If the tilt settings are exceeded,
the alarm makes a sound and the light illuminates.
The platform must be lowered and retracted
immediately. If you do not obey, there is a risk of
death or serious injury.
213205AAA
70
6.2-1 Platform uphill
If the MEWP becomes tilted with the platform uphill
(refer to
to a lowered and retracted position.
1. Lower the jib to horizontal (if equipped)
2. Fully retract the main boom
3. Fully lower the boom.
4. Drive to a firm, level surface.
6.2-2 Platform downhill
If the MEWP becomes tilted with the platform downhill
(refer to
to a lowered and retracted position.
1. Fully retract the boom.
2. Drive to a firm, level surface.
Figure 02 Platform uphill
Figure 03 Platform downhill
Figure
02), follow the steps below to go back
Figure
03), follow the steps below to go back
Chassis tilt recovery
SJ82 T, SJ86 T
Advertisement
Table of Contents
