Table of Contents
Advertisement
Section 5 – Operation
WARNING
Do not operate this MEWP without authorization
and training. If you do not obey, there is a risk of
death or serious injury.
Do these tasks in sequence before MEWP operation:
1. Visual and daily maintenance inspections. Refer
to
Section
4.2.
2. Function tests. Refer to
3. Worksite inspection. Refer to
4. If a risk assessment finds that a rescue plan is
necessary, make sure you have a system of
communication. The communication must be
between the personnel on the platform and
the selected support personnel. The selected
support personnel must know how to use the
base controls to lower the platform.
WARNING
Do not operate the MEWP if:
It does not operate correctly
▪
It is damaged or shows worn or missing parts
▪
The safety devices are tampered with or
▪
disabled
It is locked and tagged for servicing or repair
▪
It was modified without permission from
▪
Skyjack and the MEWP owner.
If you do not obey, there is a risk of death or
serious injury.
WARNING
Do not operate the MEWP with engine power in a
closed space. Only operate the MEWP with engine
power in an open or well-ventilated area. If you do
not obey, there is a risk of death or serious injury.
213205AAA
62
Section
4.3.
Section 2.4
5.1 Energize the base control
console
WARNING
Fall hazard. Use the three points of contact
principle when you enter or exit the platform. If
you do not obey, there is a risk of death or serious
injury.
1. Enter the platform and close the gate or drop
bar.
2. Pull the emergency-stop button on the platform
control console.
3. Exit the platform.
4. Turn the main power disconnect switch to the
on position.
5. Turn the off/base/platform key switch to the
base position.
6. Pull the emergency-stop button on the base
control console.
WARNING
If you do not hear a beep, and the light does not
come on, lock and tag the MEWP . Remove the
MEWP for servicing. If you do not obey, there is a
risk of death or serious injury.
7. Select the start position from the start/function
enable/emergency power switch until the
engine starts.
WARNING
Do not over crank the starter. If the engine does
not start after you try to start it multiple times,
lock and tag the MEWP . Remove the MEWP for
servicing. If you do not obey, there is a risk of
death or serious injury.
If your MEWP has the cold or arctic weather package
option installed, refer to
Section 5.24
information.
for additional
SJ82 T, SJ86 T
Advertisement
Table of Contents
