Using The Fx30S As A Usb Modem; Using The Fx30S As An Embedded Platform For Iot Applications; At Commands - Sierra Wireless FX30S User Manual

Sierra Wireless FX30S User Guide
Rev 2 Mar.18

Using the FX30S as a USB modem

You can use the FX30S as a USB bitpipe modem based on the Qualcomm
proprietary RMNET interface. This can be done through AT commands using
AT!SCACT to open and close the data session. For more information and a
detailed example, see Appendix B
Using the FX30S as an Embedded Platform for
IoT Applications
To configure or program the FX30S, you can use:
•

AT Commands

• Linux Shell Commands
• Legato Application Framework
AT Commands
Note: Ensure that your computer is set up to issue AT commands to the FX30S. (See
Setup for AT Commands.)
The radio module for the FX30S is the Sierra Wireless AirPrime
radio module AT commands include:
• Test AT command interface: AT should answer OK
• Get device information: ATI
• Get SIM status: AT+CPIN?
• Enter SIM PIN code: AT+CPIN=XXXX
• Configure APN: AT+CGDCONT=1,"IP","xxxxxx.xxx"
• Check APN configuration: AT+CGDCONT?
• Check signal quality: AT+CSQ
• Check network registration: AT+CREG?
• Check GPRS network registration: AT+CGREG?
• Check operator selected: AT+COPS?
• Check for PDP context status: AT+CGACT?
• Check for modem status: AT!GSTATUS?
• Open a LWM2M session to connect AirVantage: AT+WDSS=1,1
For a complete list of AT Commands for the WP8548 radio module, refer to the
WPx5xx AT Command Reference
In addition, the AT Commands in
Note: Parameters in angled brackets < > are mandatory. Parameters in square brackets [ ]
are optional.
34
on page 70.
on page 42
on page 42
(document number 4118047).
Table 2-6 are specific to the FX30S.
®
WP8548. Useful
41110485