Using The Fx30 As A Usb Modem - Sierra Wireless FX30 User Manual

B: Using the FX30 as a USB Modem
The following instructions provide examples based on Telus service. Substitute the
name of your mobile network operator (MNO). Key values and parameters are bolded
for emphasis in the examples.
For detailed information about the AT commands used, refer to AirPrime WPx5xx AT
Command Reference (4118047) available at source.sierrawireless.com.
To use the FX30 as a USB modem:
1. Ensure that your computer is set up to issue AT commands to the FX30. (See
2. Connect the radio to the network:
3. Activate the PDP context:
Rev 4 March 2019
Setup for Windows on page 31.)
a. If you have not already done so, install the SIM card. (See
SIM Card and Optional IoT Card
b. Set the MNO's APN using the AT+CGDCONT command. (Most MNOs use
Profile number 1. To confirm, check with your MNO.)
AT+CGDCONT=1,"IPV4V6","isp.telus.com"
c. Check that the profile is correctly set:
AT+CGDCONT?
+CGDCONT: 1,"IPV4V6","isp.telus.com","0.0.0.0",0,0
d. Check that the radio is attached and registered on the network.
AT!GSTATUS?
!GSTATUS:
Current Time: 5699
Bootup Time: 0
System mode: WCDMA
WCDMA band: WCDMA 1900
WCDMA channel: 662
GMM (PS) state:REGISTERED
MM (CS) state: IDLE
WCDMA L1 State:L1M_PCH_SLEEP
RRC State: DISCONNECTED
761C (1108 30236)
RxM RSSI C0: -80
RxM RSSI C1: -106
IMS Reg State: UNKNOWN
IMS Srv State: UNKNOWN SMS,UNKNOWN VoIP
OK
a. Use the Profile number prepared in steps 2b and 2c above.
AT!SCACT=1,1
b. Check the profile is active:
AT!SCACT?
!SCACT: 1,1
62
Step 1—Insert the
on page 11.)
Temperature: 31|
Mode: ONLINE
PS state:
NORMAL SERVICE
NORMAL SERVICE
LAC: 2B5D (11101)
UTRAN Cell ID:
RxD RSSI C0: -106
RxD RSSI C1: -106
IMS Mode:
B
Attached
0454
Not Support
41110030